Providing these toilet things are fine there is the chance that the cord running to the disposal has developed a short or a wire has become disconnected. You will need to disassemble the unit to verify all wires remain securely fastened. The last conclusion is that the motor has burned out, in which case you will need to replace the disposal unit.
After you have checked these areas, take a close look around the refrigerator, both inside and outside. Is there any usual condensation that could indicate a water leak somewhere? Is the icemaker hose fastened securely to the water line repair line? Check also for any water spots on the floor, as these are typically clear signs of a water leak somewhere.
In repairing a tub faucet, you will notice that there will be drips that you need to address to. With this, you will need to replace the washers and/or seats.
Dirty waste water, after all, leaves your house following the law of gravity. Waste water goes downward to the sewer or septic tank, nice and easy. Behind this simple rule is the multitude of vents and traps to keep the process of waste removal possible. Vents allow air to fill drainpipes, precious air that allow waste water outflow. Traps are those curved S-shaped sections of the pipes under the sink drain. Traps perform a crucial role in forcing most of the water through the drainpipe, but leaving some to seal the area and prevent sewer gas from backing up.
Keep an eye on any leaks in and around the house. Inspect taps, pipes and your roof regularly. Watch for leaks and if you find them, get it water line repair as soon as possible.
And the way to know what's sufficient? Well, until the work is done an the bill paid you won't know for certain, but this is the best that can be suggested and normally works very well.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.